Matching a set of mixed locks
Three exterior doors carry three different makes and finishes. We suggest a matching set that shares one key, then fit it using the existing holes.
Worn, outdated or damaged locks are worth replacing when repair or rekeying will not do. We check the door, fit the new hardware and test it before we leave.
A new lock is a straightforward job when the door is prepared to standard sizes: a 2-1/8 inch cross bore, a 1 inch edge bore and a 2-3/8 or 2-3/4 inch backset. We reuse the existing holes where we can, so the door is not weakened or marked. Replacement is not automatic. If the hardware is sound, rekeying may solve the problem with less work, and we tell you which route suits your door.
Many homes in Shellmont and East Cambie have gone through several rounds of hardware changes, so a front door may have a modern deadbolt and an older knobset beside it. Condo units in City Centre are often fitted with a finish chosen by the developer, and some stratas set rules on what may be installed. Coastal damp can pit brass and loosen mounting screws over time, which is worth checking when a handle feels loose.
Most residential locksets fit a 2-1/8 in. cross bore, a 1 in. edge bore and a 2-3/8 or 2-3/4 in. backset, on doors 1-3/8 to 1-3/4 in. thick.
Typical reasons people in Richmond call about residential lock installation and replacement.
Three exterior doors carry three different makes and finishes. We suggest a matching set that shares one key, then fit it using the existing holes.
A forced door leaves a bent latch and a loose frame. We replace the lock, inspect the strike and frame, and point out reinforcement that would help.
A few details that make the first call quicker and the visit more accurate.
The Lock Doc is mobile: the technician comes to the home, business or vehicle anywhere in Richmond and the nearby areas below. Call with the address and we will tell you when someone can be there.
Not always. If the lock is in good condition, rekeying changes the key without replacing the hardware. Replacement makes sense when the lock is worn, damaged or no longer suits the door, and we explain the difference before work starts.
Usually, if the new hardware suits the door and your strata allows it. Check bylaws or rules with the building manager first, since some buildings require a particular style or key system for unit doors.
Guides that go deeper on this kind of job.
Call with the address or send the details online. The phone is answered 24/7.