Skip to content
The Lock Doc

Deadbolt Installation in Langley, BC

A deadbolt only protects a door as well as the frame holding it. We check the door, frame and strike first, then fit a bolt that engages cleanly.

Request service

For immediate help, call +1 236 800 LOCK. Submitting this form does not confirm an appointment.

Fitting solid deadbolts on Langley doors

Fitting a deadbolt takes more than a cylinder on the door. The bolt has to throw fully into a strike that is screwed into the framing, not only the thin trim, and the door has to hang squarely enough for the bolt to line up. Before fitting anything, we check thickness, material, backset and the state of the frame, and we reuse existing bore holes when they suit the hardware.

Many Willoughby and Walnut Grove homes already have a deadbolt on the front door, but side doors, patio entries and the garage-to-house door are sometimes fitted with only a latch. Those secondary doors are where an added deadbolt often makes the most difference, as long as the frame can support a longer throw.

Older Brookswood and Murrayville houses may have thin or worn frames, painted over many times, so the strike plate sits in soft wood. Longer screws that reach the stud, and a reinforced strike, help the bolt hold. On acreages near Salmon River or Glen Valley, a detached garage or workshop door may need a deadbolt suited to a steel or solid wood door.

Top-down section of a door, jamb and framing showing the bolt throw, strike plate and orange screws.
A deadbolt should throw 1 in. into a reinforced strike plate. Long 3 in. screws carry the load into the framing behind the jamb, not just the thin jamb.

How deadbolt installation works

A deadbolt should throw 1 in. into a reinforced strike plate. Long 3 in. screws carry the load into the framing behind the jamb, not just the thin jamb.

Common situations in Langley

Typical reasons people in Langley call about deadbolt installation.

A side door with only a latch

The garage-to-house door in a Willoughby home has a simple knob lock. We assess the door and frame and add a deadbolt if the door is thick enough.

Bolt that will not line up

A Murrayville door has settled, so the bolt scrapes the strike. We check hinges and frame first, then realign or relocate the strike rather than forcing the bolt.

Single or double cylinder

A patio door with glass beside it raises the question of a key on the inside. We explain how a double cylinder affects getting out quickly in an emergency.

Before you call

A few details that make the first call quicker and the visit more accurate.

  1. Photograph both sides of the door and frame, including the area around the strike.
  2. Measure the door thickness and the distance from the door edge to the centre of the existing bore if you can.
  3. Decide whether the deadbolt should match your existing key or have its own.
  4. Think through who needs to exit the door quickly and how, especially if there is glass nearby.

Where we work in Langley

The Lock Doc is mobile: the technician comes to the home, business or vehicle anywhere in Langley and the nearby areas below. Call with the address and we will tell you when someone can be there.

Map of Langley neighbourhoods served: Willoughby, Walnut Grove, Murrayville, Brookswood, Fort Langley, Aldergrove, Langley City, Willowbrook
Neighbourhoods across Langley and the nearby areas we also cover: Surrey, Pitt Meadows, Maple Ridge, Coquitlam. Locations are approximate.

Deadbolt Installation questions in Langley

Can any Langley door take a deadbolt?

Most solid exterior doors can, but thin or hollow doors, or doors with a damaged frame, may not hold one well. We check thickness and condition first and say so if the door or frame needs attention before a bolt will do its job.

Why is my deadbolt hard to turn in wet weather?

Wooden doors swell in the rainy months, so the bolt may rub against the strike. Adjusting the strike or easing the door usually fixes it. A worn cylinder can also cause trouble, which is why diagnosis comes before replacement.

Should my deadbolt match the rest of my locks?

It can. A deadbolt can be keyed to match your existing entry lock so one key does both jobs, as long as the cylinders are compatible. Otherwise a new key is supplied for it, and we will tell you which route fits your hardware.

Need a locksmith in Langley?

Call with the address or send the details online. The phone is answered 24/7.