Skip to content
The Lock Doc

Residential Lock Installation and Replacement in Port Coquitlam, BC

Replacing a worn lockset or fitting a new one on a Port Coquitlam door starts with the door itself. We measure, match the hardware and test it.

Request service

For immediate help, call +1 236 800 LOCK. Submitting this form does not confirm an appointment.

Replacing locks on Port Coquitlam homes

Most residential doors share standard prep: a 2-1/8 inch cross bore, a 1 inch edge bore and a backset of either 2-3/8 or 2-3/4 inches. Matching those measurements lets a new lockset reuse the existing holes. Older buildings sometimes have mortise locks that need a different approach, and a technician will confirm what your door has before suggesting hardware.

Renovated houses around Lincoln Park and Downtown often have a new front door paired with a lockset from the original build, or the reverse, so mismatched finishes and worn internals are common. In Riverwood and Oxford Heights, sets tend to be newer, and replacement is usually driven by style, a lost key or a move to a matched keying system.

Face and edge views of a door showing the cross bore, backset, edge bore and door thickness.
Most residential locksets fit a 2-1/8 in. cross bore, a 1 in. edge bore and a 2-3/8 or 2-3/4 in. backset, on doors 1-3/8 to 1-3/4 in. thick.

How residential lock installation and replacement works

Most residential locksets fit a 2-1/8 in. cross bore, a 1 in. edge bore and a 2-3/8 or 2-3/4 in. backset, on doors 1-3/8 to 1-3/4 in. thick.

Common situations in Port Coquitlam

Typical reasons people in Port Coquitlam call about residential lock installation and replacement.

Tired lockset after years of use

The finish has worn through on a Birchland Manor door and the key sticks. A replacement set that fits the existing holes avoids drilling a fresh door.

Matching a renovated entry

A homeowner in Mary Hill has fitted a new front door and wants lock hardware that suits it. We check the prep and fit a set that closes cleanly.

Before you call

A few details that make the first call quicker and the visit more accurate.

  1. Note the finish and style you want, whether knob, lever or handle set.
  2. Measure the door thickness if you can, and check for a deadbolt hole above the lock.
  3. Tell us whether the new lock should take the same key as your other doors.

Where we work in Port Coquitlam

The Lock Doc is mobile: the technician comes to the home, business or vehicle anywhere in Port Coquitlam and the nearby areas below. Call with the address and we will tell you when someone can be there.

Map of Port Coquitlam neighbourhoods served: Downtown, Mary Hill, Citadel Heights, Oxford Heights, Riverwood, Birchland Manor, Lincoln Park, Glenwood
Neighbourhoods across Port Coquitlam and the nearby areas we also cover: Coquitlam, Pitt Meadows, Port Moody, Maple Ridge. Locations are approximate.

Residential Lock Installation and Replacement questions in Port Coquitlam

Do I have to replace the whole lock if the key sticks?

Not always. A repair or rekey can sometimes solve it. If the cylinder is worn badly or the lock is obsolete, replacement is the better value, and the technician explains which applies after diagnosing it.

Can new hardware use my existing door holes?

Usually, when it matches standard bore and backset sizes. A different lock style or an older mortise door may need adjustments, which we point out before we start.

Need a locksmith in Port Coquitlam?

Call with the address or send the details online. The phone is answered 24/7.