Skip to content
The Lock Doc

Deadbolt Installation in Burnaby, BC

A deadbolt only works as well as the door and frame around it. We check both, fit a compatible bolt and set the strike so it engages cleanly on your Burnaby entry.

Request service

For immediate help, call +1 236 800 LOCK. Submitting this form does not confirm an appointment.

Fitting deadbolts on Burnaby entry doors

Good deadbolts throw a solid bolt into a reinforced strike held by long screws that reach the framing behind the trim. On Burnaby homes, the lock is often fine and the weak point is a short-screwed strike or a loose frame. The technician checks door thickness, backset and frame before choosing hardware, and tests the bolt several times before leaving.

Townhouse rows near Highgate and Royal Oak, and houses in Willingdon Heights, can have steel or fibreglass-clad doors with standard bores that suit common deadbolts. Where a door already has the holes, a new deadbolt can reuse them. A single cylinder is the usual choice; a double cylinder needs a key inside and can slow your exit in an emergency.

Older houses in Burnaby Heights and on Capitol Hill may have a wood door with a worn latch-only lockset and no deadbolt at all. Fitting one means drilling a new cross bore and edge bore. Wet weather swells wood, so the technician checks how the door sits and may adjust the strike so the bolt still throws smoothly.

Top-down section of a door, jamb and framing showing the bolt throw, strike plate and orange screws.
A deadbolt should throw 1 in. into a reinforced strike plate. Long 3 in. screws carry the load into the framing behind the jamb, not just the thin jamb.

How deadbolt installation works

A deadbolt should throw 1 in. into a reinforced strike plate. Long 3 in. screws carry the load into the framing behind the jamb, not just the thin jamb.

Common situations in Burnaby

Typical reasons people in Burnaby call about deadbolt installation.

Latch-only lock on a Heights door

An older front door in Burnaby Heights has only a spring latch. A deadbolt is added with a reinforced strike, after the door and frame are checked for soundness.

A secondary suite entrance

A new basement suite on the South Slope needs its own deadbolt. The door is prepared, the bolt fitted and keyed separately from the main house.

A bolt that rubs the strike

In a Highgate townhouse, the deadbolt scrapes and will not fully extend. The strike is repositioned or the door adjusted so the bolt throws freely.

Before you call

A few details that make the first call quicker and the visit more accurate.

  1. Take photos of both sides of the door and the frame, including the strike plate and the hinges.
  2. Measure the door thickness if you can, and note whether the door is wood, steel or fibreglass.
  3. Decide how many keys you want to carry, so the new deadbolt can match your other locks.
  4. For a strata townhouse, ask whether finish or hardware rules apply to exterior doors.

Where we work in Burnaby

The Lock Doc is mobile: the technician comes to the home, business or vehicle anywhere in Burnaby and the nearby areas below. Call with the address and we will tell you when someone can be there.

Map of Burnaby neighbourhoods served: Metrotown, Brentwood, Edmonds, Burnaby Heights, Lougheed, Capitol Hill, South Slope, Burnaby Mountain
Neighbourhoods across Burnaby and the nearby areas we also cover: Vancouver, New Westminster, Coquitlam, Port Moody. Locations are approximate.

Deadbolt Installation questions in Burnaby

What backset does a deadbolt on my door need?

Most residential doors use a 2-3/8 or 2-3/4 inch backset with a 2-1/8 inch cross bore and a 1 inch edge bore. The technician measures your door before choosing hardware, so you do not need to guess in advance.

Is a double cylinder deadbolt a good idea for a house?

It needs a key to open from inside as well as outside, which can slow your exit in an emergency. It suits doors with glass nearby in some cases, but a single cylinder is the usual choice. The technician can discuss the trade-off.

Can a deadbolt be added to a Burnaby townhouse door?

Often, yes, once the door and frame are checked. In a strata complex, check the rules on hardware for exterior doors before the visit. The technician confirms the door can take the extra bore and that the strike can be fixed into the framing.

Need a locksmith in Burnaby?

Call with the address or send the details online. The phone is answered 24/7.