Skip to content
The Lock Doc

Panic Bar Installation in Burnaby, BC

A damaged or sticking exit bar, or a new door that needs one? We check the door, frame and rating, then fit exit hardware that releases reliably.

Request service

For immediate help, call +1 236 800 LOCK. Submitting this form does not confirm an appointment.

Panic bars and exit hardware in Burnaby

People leave a building with one push on a panic bar, which makes it life-safety equipment rather than an accessory. Burnaby businesses replace them when bars bind, latches fail to retract or the door will not close fully. They are common on rear exits of Kingsway restaurants, staff doors in Metrotown retail, training spaces near BCIT and industrial units around Big Bend.

There are several types: rim devices for the surface of a single door, surface vertical rod models for pairs of doors, concealed vertical rod types that look cleaner and mortise exit devices for heavier use. Which fits depends on door size, material and any fire rating. A fire-rated door has extra requirements, so we check before we choose a device.

The door and frame matter as much as the bar. A door that has dropped, a bent strike or a closer that is out of adjustment will make any device feel faulty. We check these first, fit the bar, test it from both sides and confirm the door closes and latches. Never block, chain or prop an exit door to avoid the problem.

Four exit device types on door outlines: rim, surface vertical rod, concealed vertical rod and mortise, with the push bar in orange.
Exit devices differ in how they latch: at the edge, with rods at the top and bottom, or with a mortise case. Fire-rated doors have extra requirements.

How panic bar installation works

Exit devices differ in how they latch: at the edge, with rods at the top and bottom, or with a mortise case. Fire-rated doors have extra requirements.

Common situations in Burnaby

Typical reasons people in Burnaby call about panic bar installation.

A restaurant rear exit sticks

A Kingsway kitchen's back door bar needs a hard shove and sometimes fails to latch. Cause and cure may be the device, the door sag, or the closer, so we check all three.

A new fit-out needs exit hardware

A unit in Metrotown is being converted to a new use and the rear door needs a proper exit device. We identify one that suits the door's size, material and any rating.

Exit hardware on a double door

An industrial unit near Big Bend has paired steel doors with worn bars. Vertical rod hardware may suit them, and we check the frame and alignment before ordering anything.

Before you call

A few details that make the first call quicker and the visit more accurate.

  1. Take clear photos of both sides of the door, the frame and the existing device.
  2. Note whether the door has a fire rating label, and whether it is a single or paired door.
  3. Tell us whether the door needs an exterior key or trim for outside access.
  4. Keep the exit route clear at all times; do not chain or block the door while waiting.

Where we work in Burnaby

The Lock Doc is mobile: the technician comes to the home, business or vehicle anywhere in Burnaby and the nearby areas below. Call with the address and we will tell you when someone can be there.

Map of Burnaby neighbourhoods served: Metrotown, Brentwood, Edmonds, Burnaby Heights, Lougheed, Capitol Hill, South Slope, Burnaby Mountain
Neighbourhoods across Burnaby and the nearby areas we also cover: Vancouver, New Westminster, Coquitlam, Port Moody. Locations are approximate.

Panic Bar Installation questions in Burnaby

Can I replace a panic bar myself?

It is risky to try. Exit devices are life-safety equipment and the right model depends on the door and its rating. A badly fitted bar can fail when needed, so it is worth having the opening assessed and the work tested.

Does a fire-rated door change what you can install?

Yes. Fire-rated openings have extra requirements for hardware, closers and sometimes how the door is prepared. We look for rating labels and choose a device accordingly, and we do not alter a fire door in ways that would void it.

My exit door near Big Bend is steel. Is that a problem?

Not usually. Steel doors take rim and vertical rod devices well, provided the door is solid and aligned. Reinforcement plates and the right fasteners are part of the job. We check for corrosion too.

Need a locksmith in Burnaby?

Call with the address or send the details online. The phone is answered 24/7.