Skip to content
The Lock Doc

Commercial Lock Installation in Burnaby, BC

Worn, loose or mismatched hardware on a business door? We check the whole opening, choose commercial-grade hardware to suit and fit it for daily use.

Request service

For immediate help, call +1 236 800 LOCK. Submitting this form does not confirm an appointment.

Fitting commercial-grade locks in Burnaby

Residential locks do not last on a door that opens hundreds of times a day. Commercial hardware is rated by ANSI/BHMA grade, with Grade 1 the heaviest duty, and it comes as cylindrical, mortise or rim types. In Burnaby we replace worn locks in strip-mall units on Kingsway, office suite doors near Lougheed Town Centre and common-area doors in strata buildings around Metrotown.

Older commercial buildings along Hastings Street and Canada Way sometimes have mortise locks set into the door edge, which suit some replacements and not others. Newer offices usually take cylindrical locksets in standard prep. We measure the cross bore, edge bore and backset first and reuse existing holes where possible to keep the door tidy.

Wet winters affect entrance doors. Timber doors swell and aluminum doors collect grit, so a latch that was fine in summer may drag by November. Door closers are checked at the same time, because a closer set too hard strains the latch and a weak one leaves the door unlatched.

ANSI/BHMA grade ladder from Grade 3 residential to Grade 1 heavy commercial, beside sketches of lever, mortise and rim locks.
Grade 1 is the heaviest commercial duty, Grade 2 suits light commercial use and Grade 3 is residential. The right grade and lock type depend on how the door is used.

How commercial lock installation works

Grade 1 is the heaviest commercial duty, Grade 2 suits light commercial use and Grade 3 is residential. The right grade and lock type depend on how the door is used.

Common situations in Burnaby

Typical reasons people in Burnaby call about commercial lock installation.

A suite lock fails weekly

A consulting office near Lougheed has a lockset that jams most weeks. The latch is worn out and the door has sagged slightly, so the hardware and the alignment are both addressed.

Mismatched locks across a unit

A Kingsway retailer has three different locks on front, back and storage doors. Replacing them with one matched, commercial-grade line makes keying simpler. The keys then become simpler to track.

A strata amenity door that keeps failing

A common-area door near Metrotown takes constant use from residents. Heavier-duty hardware is fitted and the closer is adjusted so the door latches every time.

Before you call

A few details that make the first call quicker and the visit more accurate.

  1. Photograph the door, lock and edge, and measure its thickness if you can.
  2. Describe how many times a day the door is used and by whom.
  3. Note whether the door must stay unlocked during business hours.
  4. Confirm who approves hardware changes, especially in leased or strata buildings.

Where we work in Burnaby

The Lock Doc is mobile: the technician comes to the home, business or vehicle anywhere in Burnaby and the nearby areas below. Call with the address and we will tell you when someone can be there.

Map of Burnaby neighbourhoods served: Metrotown, Brentwood, Edmonds, Burnaby Heights, Lougheed, Capitol Hill, South Slope, Burnaby Mountain
Neighbourhoods across Burnaby and the nearby areas we also cover: Vancouver, New Westminster, Coquitlam, Port Moody. Locations are approximate.

Commercial Lock Installation questions in Burnaby

What does Grade 1 mean on a commercial lock?

It is the top rating in the ANSI/BHMA system and means the hardware is tested for the heaviest duty. Many offices do well with Grade 2, while busy public doors lean toward Grade 1. We suggest the grade that suits the door.

Can you replace a lock without replacing the door?

Usually, yes. The new lock is chosen to fit the existing prep, or to reuse the holes with a compatible model. If the door itself is damaged or out of square, we tell you what that means.

Do you fit locks in Brentwood towers with a landlord-controlled core?

On suite doors, with approval from whoever controls the lease or building. Core, lobby and stairwell hardware is normally the landlord's, so we confirm that before any change. Their approval may be needed in writing.

Need a locksmith in Burnaby?

Call with the address or send the details online. The phone is answered 24/7.