Matching keys across a new build
A Grandview Heights owner wants the front, side and garage doors on one key with a consistent finish. We replace the sets and key them together.
Replacing worn hardware on an older Cloverdale house or fitting new locks on a Grandview Heights townhouse starts with the door itself. We check the fit first, then install.
Any new lock needs to suit the door it goes into. Most residential doors take a 2-1/8 inch cross bore and a 1 inch edge bore, with a backset of either 2-3/8 or 2-3/4 inches, and when your door matches that, existing holes can be reused. Surrey homes span new builds and older houses, so we measure and test the opening before choosing between a simple swap and anything more involved.
New construction in Grandview Heights, Clayton and Sullivan Heights tends to come with standard prepared doors, which makes a swap straightforward. Owners often replace builder hardware when they want matching keys across doors, a nicer finish or a different function such as a keyed entry set with a separate deadbolt.
Older homes in Cloverdale, Whalley and Guildford can be less predictable. Doors may have been trimmed, drilled twice or fitted with a mortise lock that does not match modern bores. We would rather tell you that a door needs preparation than force hardware into a poor fit, and we point out frame damage that would undo a new lock.
Most residential locksets fit a 2-1/8 in. cross bore, a 1 in. edge bore and a 2-3/8 or 2-3/4 in. backset, on doors 1-3/8 to 1-3/4 in. thick.
Typical reasons people in Surrey call about residential lock installation and replacement.
A Grandview Heights owner wants the front, side and garage doors on one key with a consistent finish. We replace the sets and key them together.
The lock still works but the frame is split. We repair or reinforce the strike area, then fit the new hardware so it holds against the door.
A twenty-year-old handleset has loose fasteners and a worn latch. We fit a compatible replacement that reuses the existing holes and keep the old finish match where possible.
A few details that make the first call quicker and the visit more accurate.
The Lock Doc is mobile: the technician comes to the home, business or vehicle anywhere in Surrey and the nearby areas below. Call with the address and we will tell you when someone can be there.
No. You can, and we will check that it suits your door, but we can also supply compatible locks after looking at the opening. Buying before the visit sometimes leads to a lock that does not fit the door prep, so photos first are helpful.
Usually. Older doors may need drilling to take a modern lockset, or may have mortise hardware that needs a matching replacement. We look at the door and frame, then explain what is possible, rather than forcing a poor fit.
A single standard lockset on a prepared door is a short job, while several doors, an older mortise lock or frame repair take longer. We give you a realistic idea once the technician has seen the opening, and we test every lock before leaving.
Guides that go deeper on this kind of job.
Call with the address or send the details online. The phone is answered 24/7.