A handle set that has gone loose
The front door in a Central Lonsdale townhouse has a wobbly lever and a worn latch. A matching lockset is fitted in the existing bores.
When a lock is worn out, broken or no longer fits the way you live, replacing it makes sense. We check the door, match the hardware and install it so it works smoothly.
Replacement begins with the door. Most residential doors take a standard prep: a 2-1/8 inch cross bore, a 1 inch edge bore and a 2-3/8 or 2-3/4 inch backset. Older buildings can have mortise locks, which need different hardware. Where possible, existing holes are reused so the door stays intact. Diagnosis comes first, and you are told plainly if a repair or rekey would do the job instead.
Homes in Capilano, Delbrook and Central Lonsdale built decades ago often hold original or mismatched locks that have loosened with age. Townhouses and condos near Lonsdale Quay may have strata guidelines on suite door hardware, so check before choosing a finish. On the wet side of the North Shore, exterior hardware should cope with moisture and salt air near the water.
Most residential locksets fit a 2-1/8 in. cross bore, a 1 in. edge bore and a 2-3/8 or 2-3/4 in. backset, on doors 1-3/8 to 1-3/4 in. thick.
Typical reasons people in North Vancouver call about residential lock installation and replacement.
The front door in a Central Lonsdale townhouse has a wobbly lever and a worn latch. A matching lockset is fitted in the existing bores.
A house in Delbrook has three different keys for three doors. New compatible locksets are fitted and keyed alike so one key does everything.
A few details that make the first call quicker and the visit more accurate.
The Lock Doc is mobile: the technician comes to the home, business or vehicle anywhere in North Vancouver and the nearby areas below. Call with the address and we will tell you when someone can be there.
If the hardware works and looks sound, rekeying is usually the lighter fix. Replacement suits locks that are worn, damaged, mismatched or lower-grade than you want. The technician tells you which applies after inspecting them.
Usually not. Standard cross bore and edge bore dimensions let a new lockset reuse the existing holes. A door with unusual prep, or a mortise lock, may need extra work or a different part.
Guides that go deeper on this kind of job.
Call with the address or send the details online. The phone is answered 24/7.